Lighted *ESP* kill switch help

Posted on Sunday, April 2nd, 2017 at 11:13 am
Salty Soul Jeep Shirt

I’m trying to wire in a dual lighted OTRATTW switch to kill the ESP. The dash illumination for the lower light was easy, and it’s working to kill the ESP, but I can’t get the upper light to illuminate when the ESP is off. I’m also using a relay, so here’s what I have now- I have 12v in to switch on incoming pin. Outgoing from switch to 85 on relay, 86 to ground. ESP wires are connected to 87 30. And 87a is going out to incoming positive for upper switch light. (I also tried swapping 87 87a, that didn’t work either)

What am am I doing wrong? I read somewhere that the ESP wire is “data only”, would that mean it won’t have enough juice to power the LED light? Other suggestions?


Salty Soul Jeep Shirts

Article source:

Both comments and pings are currently closed.

Comments are closed.